• bjul
  • ADAT user
  • Offline
  • Registered: 2011-01-27
  • Posts: 27

Topic: [Solved] Babyface not recognized under Windows

I usually use BabyfacePro. At the moment because of the hot weather, I would like to use Babyface like I did before. But when I connect my old Babyface Totalmix doesn't appear and Babyface is not recognised.
Thanks.
Bj

2 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 24,837

Re: [Solved] Babyface not recognized under Windows

Your old Babyface might be in Class Compliant mode (in case you use Windows, which you did not mention).

Regards
Matthias Carstens
RME

MC's Website

  • bjul
  • ADAT user
  • Offline
  • Registered: 2011-01-27
  • Posts: 27

Re: [Solved] Babyface not recognized under Windows

Thanks. l am on Windows10. If Babyface is in Class Compliant mode, how do I reset it into normal mode?

4 Reply by MC

  • MC
  • MC
  • Administrator
  • Offline
  • From: Germany/Thailand
  • Registered: 2007-04-06
  • Posts: 24,837

Re: [Solved] Babyface not recognized under Windows

Manual page 12 chapter 6:

In case the level meters of the Babyface run up during power-on: the unit is in Class Compliance mode and will not be working under Windows. Remove the cable, hold Select and Recall button down, plug-in the USB cable. This procedure changes between the CC and normal mode. When the LED Level meters don’t run up during power-on the normal mode is active.

Regards
Matthias Carstens
RME

MC's Website

  • bjul
  • ADAT user
  • Offline
  • Registered: 2011-01-27
  • Posts: 27

Re: [Solved] Babyface not recognized under Windows

It works, thank you!