Topic: Firefac UFX Optical
I am trying to connect a gaming console to my Fireface UFX to get output to my monitors through spdif, but it don't seem like the Fireface are picking up any signal that indicates audio. Any suggestions?
You are not logged in. Please login or register.
RME User Forum → FireWire & USB series → Firefac UFX Optical
I am trying to connect a gaming console to my Fireface UFX to get output to my monitors through spdif, but it don't seem like the Fireface are picking up any signal that indicates audio. Any suggestions?
The gaming console might send a surround signal in AC-3 format. Try to change that to stereo.
I have tried it. I have connected it to ADAT 1, but no signal is shown in ADAT 1/2 in TotalMix.
Does the Settings dialog say that you have an SPDIF input signal? You have to set stereo in your GAMING CONSOLE, then use the correct SPDIF input at the UFX (which is ADAT 2).
I have now plugged the Optical cabel from my Xbox to ADAT2 input.
On the Xbox One Optical sound is set to Stereo uncompressed.
This is how the TotalMix looks like.
The Settings dialog, not the TotalMix Settings...
And revert that Listenback entry to None or you will get problems later on,.
Thank you that worked! I reverted the Listenback entry. Can leaving it there cause hardware problems?
Input is not in Sync because Clock Source is not set to AES/SPDIF. 'Sample rate' should match the one reported from input.
Ok, do I don't have to worry that I can have done any harm to the interface due to the input listenback setting? I thik it only was there for an hour.
RME User Forum → FireWire & USB series → Firefac UFX Optical
Powered by PunBB, supported by Informer Technologies, Inc.