Topic: BabyFace & OSX High Sierra (Not Working) driver 3.03

I'm using the original 'BabyFace' with the OSX 3.03 driver
just upgraded to High Sierra
but now the BabyFace don't show up in audio devices and the Matrix /Mixer won't load

I had a version of High Sierra BETA and with the 3.03 driver - it was working fine

can anyone from RME look into this

thanks
M

2

Re: BabyFace & OSX High Sierra (Not Working) driver 3.03

You might need to reinstall USB driver 3.03 so that the Security & Privacy dialog shows a button 'Allow' for the RME kernel extension. This button disappears after 30 minutes. Then you need to install the driver again to be able to click 'Allow'.

https://developer.apple.com/library/con … index.html

Regards
Matthias Carstens
RME

3 (edited by MartinG 2017-09-29 18:55:04)

Re: BabyFace & OSX High Sierra (Not Working) driver 3.03

Great That worked!!

here's  how:
1. System preferences:  security and settings - allow apps from apple & identified
2. install RME Driver 3.03
3. Restart
4. System preferences (Again) :  Click on the new button, which allow RME driver to be installed
Done

Re: BabyFace & OSX High Sierra (Not Working) driver 3.03

My name is Camilo Christófaro.
I have a Fireface 802, when updating the operating system of Apple High Sierra, I have had problems with audio locking and small clicks (noise) in the recording.
I saw in some sites that RME claimed not to have problems with the new operating system, but even in the Business Forum I found complaints.

Are you planning to update your Drive?

Thank you very much in advance.

Re: BabyFace & OSX High Sierra (Not Working) driver 3.03

I use Imac 2015 .

Thans

Re: BabyFace & OSX High Sierra (Not Working) driver 3.03

Try a clean installation of High Sierra (instead of an upgrade).

Re: BabyFace & OSX High Sierra (Not Working) driver 3.03

MartinG wrote:

Great That worked!!

here's  how:
1. System preferences:  security and settings - allow apps from apple & identified
2. install RME Driver 3.03
3. Restart
4. System preferences (Again) :  Click on the new button, which allow RME driver to be installed
Done

Godsend, this solved it for my UCX. Thanks so much!