It worked, thank you.

Apart from > Window 100% - 135% - 200% options in TM Fx, any chance a user can select for the whole TM Fx window to occupy the whole PC screen?

With 100% - 135% - 200% options only 70% of the screen shows the TM Fx.

I have wiggled with my PC settings, but couldn'm make it work.

Not just CPU, dynamic resizing is not good for accurate metering.

I have a stereo compressor now in my setup and wanted to discuss the connection with the UFXll.

I put a mic in front of my amp, the mic goes to input 9 (mic/line) on the FF.

From the XLR outs (1&2) of the FF I've connected cables to ins of my compressor.

From the compressor's outs I've connected cables to FF ins 7 & 8.

Is this a proper way to do it in order to have the mic signal going to FF, then out to compressor, and back to inputs 7 & 8, so the 'returned' compressed sound can be sent to DAW and recorded?

Thanks.

You get this info from webpage.

Thank you for that Daniel.

I have recorded a simple bass drum pattern into my DAW (Cubase), then I have connected the outputs 1 & 2 from the FF to the inputs of the pre-amp, then to compressor, and out of compressor back to audio inputs
on the FF.

I'm experiencing some noise that comes with the bass drum as in the recording below.

Obviously I am doing something wrong??!

https://soundcloud.com/user-169958534/bass-drum-buzzing

Thanks, now I went without compressor.
From FF outs to 1073 line ins > back to FF, this is what the bass drum sounds like.

https://soundcloud.com/user-169958534/b … compressor

.