1 Topic by Vaughn (edited by Vaughn 2019-07-14 21:31:29)

  • Registered: 2007-06-12
  • Posts: 10

Topic: Problem ff800 : I can connect but only with this workaround

Hello

Here's the problem :

I can connect with FW, the device is recogniced by my computer (imac and MBP) BUT when launching Logic Pro (9 or/and 10) only 2 inputs recieve signal there
Although both totalmix and ff800 indicate the signal

To make it work I disconnect and reconnect FF800 while Logic pro is open, forcing the software to reinitialize core audio.
First then It sees/recieves all inputs

The problem occurs under 3 different os x and 2 versions of Logic pro, and with 2.77+3.06 drivers and latest drivers too
Is it a hardware issue with the FW in the FF800? And if so can I buy the part and change it like i've done with the transfo?

Kind regards
Vaughn

  • From: Germany
  • Registered: 2007-04-10
  • Posts: 9,547

Re: Problem ff800 : I can connect but only with this workaround

Does this also happen with other software, e.g. Reaper?
Not likely a Firewire issue, though.


Regards
Daniel Fuchs
RME

Regards
Daniel Fuchs
RME

RME Support's Website

3 Reply by Vaughn (edited by Vaughn 2019-07-23 21:36:42)

  • Registered: 2007-06-12
  • Posts: 10

Re: Problem ff800 : I can connect but only with this workaround

RME Support wrote:

Does this also happen with other software, e.g. Reaper?
Not likely a Firewire issue, though.


Regards
Daniel Fuchs
RME

Hello Daniel
Same thing in Ableton
If it's not a FW problem then what is it more likely?
I have also reset the firmware without any change